Onto the camera gear.
I attached a Runcam Swift pointing forwards to help with orientation when flying. The uptilt is probably a bit extreme for a big AP rig, but it can’t go any lower unless I find an M3 bolt with a much shallower head. I switched the Swift out for a Runcam SkyPlus from an older model as the bracket design allows the camera housing to clear the bolt head & fix at any angle.
Continue reading Tarot 650 Sport quadcopter drone built – part 2
Toward the end of 2016 I decided that I wanted a large ‘copter for aerial filming & general ‘heavy lift’; something with a full GPS autopilot with plenty of configuration flexibility/component support, some sort of standard mounting system for equipment & enough power to safely lift arbitrary payloads of maybe a few kilograms.
Continue reading Tarot 650 Sport quadcopter drone build – part 1
I’m currently building a 650 size aerial photography quad with a Pixhawk controller & discovered via a Painless360 video on YouTube that a common approach to switching between the multiple (more than 3) flight modes common to a Pixhawk AP setup is to install a 6 position switch into a Taranis using the spare port S3. This has the benefit that you don’t need to combine two of the normal switches on the Taranis, which just sounds confusing to me.
Continue reading Taranis X9D Plus 6 Position Switch Mod