Onto the camera gear.
I attached a Runcam Swift pointing forwards to help with orientation when flying. The uptilt is probably a bit extreme for a big AP rig, but it can’t go any lower unless I find an M3 bolt with a much shallower head. I switched the Swift out for a Runcam SkyPlus from an older model as the bracket design allows the camera housing to clear the bolt head & fix at any angle.
Continue reading Tarot 650 Sport quadcopter drone built – part 2
Toward the end of 2016 I decided that I wanted a large ‘copter for aerial filming & general ‘heavy lift’; something with a full GPS autopilot with plenty of configuration flexibility/component support, some sort of standard mounting system for equipment & enough power to safely lift arbitrary payloads of maybe a few kilograms.
Continue reading Tarot 650 Sport quadcopter drone build – part 1
I realised one evening that I had enough spare/unused electronics for another entire quad build, but no frame. So the following morning I went to the hardware store & bought a piece of 12mm square hardwood dowel & to make myself a frame the ‘old fashioned’ way.
Continue reading Wooden Dowel Quadcopter Drone