I’m currently building a 650 size aerial photography quad with a Pixhawk controller & discovered via a Painless360 video on YouTube that a common approach to switching between the multiple (more than 3) flight modes common to a Pixhawk AP setup is to install a 6 position switch into a Taranis using the spare port S3. This has the benefit that you don’t need to combine two of the normal switches on the Taranis, which just sounds confusing to me.
I realised one evening that I had enough spare/unused electronics for another entire quad build, but no frame. So the following morning I went to the hardware store & bought a piece of 12mm square hardwood dowel & to make myself a frame the ‘old fashioned’ way.
With winter fast approaching here in Scotland & indoor flying now representing a more realistic way to enjoy the RC hobby, I figured it was time to try one of the many F3-based brushed micro quads that Eachine have recently been releasing via Banggood.
Winter is fast approaching here in Scotland, limiting FPV opportunities, but we had a break from the rain today so I took full advantage & flew 2 locations in St Andrews that I haven’t tried before. Whether it was because of the new DAL T5045 V2 props I was using, or because of removing the ratchet on my Taranis throttle last night, or something completely unrelated, all 9 packs that I flew went swimmingly!
After building several miniquads I wanted something a little ‘different’ to work on, so I ordered the v4 tricopter from RCExplorer – that’s David Windestål’s site, you might recognise him if you watch Flite Test or Rotor Riot. I figured I’d share some pictures from the build, along with my thoughts. Overall I have to say that I love the ‘copter & it’s a joy to fly, but it was definitely the trickiest build I’ve done to date (despite being the largest overall!) & it left me quite frustrated in several places.